PIPE CUTTING & BEVELING


PIPE COLD CUTTING & BEVELING MACHINE
ALL RANGE OF PIPE CUTTING & BEVELING MACHINE - PNEUMATIC
E H WACHS -   Made in USA

Split frame Cutters- Pneumatic  from 2” to 60” dia (50 mm – 1500mm)

  • Faster Setup
  • Faster Operation
  • Lower Tooling Cost
  • Higher Performance

DynaPrep™ MDSF Features:

  • Rugged design with vastly increased form tooling capability
  • New gear design withstands force from up to a 10HP (7.5kW) drive motor
  • Ring sizes 20in and below use four clamping feet for squaring
  • New V-Lock ring mating surfaces features angled captivated bolt and keyway
  • Common cross-sectional height for tool slide commonality
  • Low sectional height fits in narrow or confined operating envelopes
  • Aluminium fixed ring for portability, steel rotating ring for strength
  • Advanced heat treating and anti-corrosion coatings for enhanced durability
  • Dual row v-bearing construction for precision and strength
  • V-bearings run in a new unique hardened steel dual raceway
  • Dual raceway design evenly distributes force loading no matter the direction
  • Only two sockets 1/2in (13mm) and 3/4in (19mm) needed for setup and operation
  • Ring sizes 24in (610mm) and up use eight clamping feet for squaring and stability
  • Indexed, squaring clamping leg design features a 2in (50mm) stroke
  • Single clamp pad extension covers a 6in (152mm) pipe diameter range
  • Clamp pads mount axially without removing the machine from the pipe
  • U shaped feet pair with push in buttons and points for miter or elbow mounting
  • Screw feet are reversible for mounting versatility, accept push-in buttons & points
  • All models feature replaceable felt wiper for lubrication and to capture chip debris
  • Detented swing bolts allow for fast positioning over inline pipe

Trav-L-Cutter

Wachs Trav-L-Cutter, or "Travel Cutter," is a portable inline pipe and pipeline cut and bevel milling machine with 6in-48in (DN150-1200) included capacity. These machines feature atmospheric anti-corrosion package with stainless steel components and special finishes.

When E.H. Wachs® is mentioned, the product that often comes to mind is our famous Trav-L-Cutter. Secured to the pipe by a special tensioning/drive chain, the Trav-L-Cutter drives itself around the pipe as it simultaneously cuts and bevels, providing a machined surface ready for welding. It's designed for severing and beveling all common pipe materials, wall thicknesses and sizes from 6 inch O.D. (DN150) on up
image
image
Agrim Projects Services : A 12, Al Habdan Towers, Sea Side Road, Mangaf, Mangaf 65452 | Phone: +965 237 122 17 | Fax: +965 237 122 18